De-dietrich DKT863X User Manual download pdf (Page 6)

INST

Attention:

Your appliance must be installed in compliance with the ins-

tructions given in this “Operating and installation instruc-

tions manual” in order to keep your food under optimum

conditions and with optimal energy consumption.

INSTALLING

• The appliance should be installed in a dry, well-ventilated room.

• Avoid balconies, verandas, and patios, the excessive heat in

summer and the cold in winter could prevent your appliance from

functioning properly, or may even damage it.

• Do not place your appliance near a heat source such as an

oven or radiator.

• Your appliance has been designed for optimum functioning at a

certain ambient temperature; it is designed for a particular cli-

mate class. This climate class is clearly indicated on the identifi-

cation plate situated on the inside of your appliance, low down

on the left wall. Outside of this temperature range, the perfor-

mance of your appliance may be reduced.

• Leave a minimum distance between your refrigerator and your

other units of 3 to 5cm at the sides and 10cm at the top, to maxi-

mise air circulation around the appliance.

•Position the appliance at a suitable distance from the wall using

the spacers provided in the accessories packet. The spacers

should be mounted on the back of the appliance.

Climate Classe Ambient Temperatures

N +16° to +32°C

ST +18° to +38°C

T +18° to +43°C

Advise:

Once you have installed your appliance, adjust its feet so

that it is tilting backwards slightly, this helps the door to

close correctly.

Before placing any food in your appliance, clean it inside

and out with a bicarbonate of soda solution (1 dessertspoon

of bicarbonate to 4 litres of water). Do flot use alcohol, scou-

ring powder or detergents, which could damage the surfa-

ces. See the section on “Cleaning your Appliance”.

ELECTRICAL CONNECTION

Attention:

For your own safety, you must comply with the instructions

given below.

Electrical installation must comply with Standard NF C *15-100,

in particular concerning the Earth.

Three-core flex 3x2.5 mm2, 230V single-phase connected to:

- 20A single-phase 230V-50Hz supply

- ELCB and an individual fuse (10 or 16A depending on the

model)

We cannot be held responsible for any incident caused by

faulty electrical installation.

Recommendations for the electrical installation of your

appliance:

• Do not use extension leads, adaptors, or socket strips.

• Always make sure your circuit is earthed.

• The socket must always remain accessible, yet be out of the

reach of children.

If you have any doubts, contact your installer.

Your appliance is compliant with European Directives CEE/73/23

(low voltage directive), CEE/89/336 (electromagnetic compatibi-

lity) and CEE/96/57 (energy efficiency) as well as their modifica-

tions.

Attention:

If the appliance has been delivered to your home in a hori-

zontal position, stand it upright and then wait 2 hours before

plugging it in. A small amount of oil may have flowed into

the refrigeration circuit, and you must allow time for this to

flow back towards the motor before connecting the

appliance. Failure to do so may damage the appliance.

Carry out an initial cleaning operation (see the section on

“Installing your appliance”) before connecting your

appliance to the electrical supply. Disconnect your

appliance prior to performing any maintenance operation.

Grasp the plug directly, instead of pulling on the power

cable.

3 INSTALLING YOUR APPLIANCE

2211

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

De-dietrich DKT863X User Manual Page 6

Comments to this Manuals

Related products and manuals for Refrigerators De-dietrich DKT863X